7. Appendix
105
Image Problems
Problem: No image appears on the screen
1.
Verify the settings on your notebook or desktop PC.
2.
Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1.
Adjust the
Focus
on the projector.
2.
Press the
AUTO PC ADJ.
button on the remote control or projector.
3.
Ensure the projector-to-screen distance is within the specified range.
4.
Check that the projector lens is clean.
5.
Remove the lens cover.
Problem: The image is blurred and distorted
1.
Check the WXGA Mode is set to Off (see page
63
).
2.
When WXGA Mode is set to On, an XGA (1024 x 768) signal may not be recognized. Set WXGA
Mode to Off if this occurs. To check if the signal is recognized, go to “Input” under “Information”
menu (see page
90
).
Problem: The image is wider at the top or bottom (trapezoid effect)
1.
Position the projector so it is as perpendicular to the screen as possible.
2.
Use the Keystone button on the remote control to correct the problem.
Problem: The image is reversed or upside down
Check the
Ceiling & Rear
setting on the
Setting
menu of the OSD.
Problem: The image is streaked
1.
Set the
Total dots
and
Fine sync.
settings on the
Adjust
menu of the OSD to the default settings.
2.
To ensure the problem is not caused by a connected PC’s video card, connect to another computer.
Problem: The image is flat with no contrast
1.
Adjust the
Contrast
setting on the
Adjust
menu of the OSD.
2.
Adjust the
Brightness
setting on the
Adjust
menu of the OSD.
Problem: The color of the projected image does not match the source image.
Adjust the
Color temp.
and
Gamma
settings on the
Detail setting
menu of the OSD.
Lamp Problems
Problem: There is no light from the projector
1.
Check that the power cable is securely connected.
2.
Ensure the power source is good by testing with another electrical device.
3.
Restart the projector in the correct order and check that the Power LED is green.
4.
If you have replaced the lamp recently, try resetting the lamp connections.
5.
Replace the lamp module.
6.
Remove the lens cap.
7.
Put the old lamp back in the projector and have the projector serviced.
Summary of Contents for PDG-DWT50KL
Page 1: ......
Page 120: ...8 Specifications 111 Cabinet Dimensions ...
Page 135: ...SANYO Electric Co Ltd KW3AL ...
