background image

3

Headphones

Connect stereo headphones (not supplied) to the PHONES socket for monitoring or for 
private listening. The speakers are automatically disconnected when headphones are 
connected.

-   Excessive sound pressure from earphones and headphones can cause hearing loss.

CD PLAY 

1

 

5

1.   Set the function switch to CD.

2.  Press the CD compartment lid (OPEN/CLOSE portion) to open it. “- -” appears on the 

display.

3.   Place the disc with the label facing up on the turntable. (Place only one disc at a time.)

4.   Press the CD compartment lid (OPEN / CLOSE portion) to close it.

 

The total track number appears on the display.

5.   Press the 

i

 button. Play starts from the 

fi

 rst track.

-   To start play from the desired track, select the track by using the

 f 

or 

e

 button, 

then press the 

i

 button.

Note:

If no disc is loaded or the disc is located with the label facing down, “- -” appears. If these 

occur, load the disc correctly or replace the damaged disc.

6.   Press the 

n

 button to end disc play back.

 

When the last track has been played, the player stops automatically.

7.   To turn the CD player off, set the function switch to OFF.

Note:

-   Do not open the CD compartment during CD play. Always press the 

n

 button and wait 

for the disc to stop rotating before opening the CD compartment.

-   This unit can play back the CD-R/RW as well. However, some CD-R/RW can not be 

played back depending on the recording conditions.

-   This unit cannot playback MP3/WMA CD or Video CD.

Notes on handling compact discs

-   Do not expose the disc to direct sunlight, high humidity or high temperature for extended 

periods of time.

-   Discs should be returned to their cases after use.

-   Do not apply paper or write anything on the disc surface.

-   Handle the disc by its edge. Do not touch the playing surface (glossy side).

-   Fingerprints and dust should be carefully wiped off the playing surface of the disc with a 

soft cloth.

 

Wipe in a straight motion from the center to the outside of the disc.

-   Never use chemicals such as record cleaning sprays, antistatic sprays or 

fl

 uids, benzene 

or thinner to clean compact discs.

Temporarily stopping play 

5

Press the 

i

 button, “

a

” blinks on the display. To resume play, press the button again.

Skip play 

4

 

8

To skip to track 6 while track 3 is playing, press the 

e

 button repeatedly until “06” appears 

on the display. To skip back to track 3 while track 6 is playing, press the 

f

 button repeatedly 

until “03” appears.

630body AU折页.indd   章节3:3

630body AU折页.indd   章节3:3

2009-6-11   14:54:33

2009-6-11   14:54:33

Summary of Contents for MCD-XP630







Reviews: