Sanyo LED-22XR10F, Service Manual

Page: 20 / 51

Factory software burned instructions listed as Table 4
Table 4 Factory software burned instructions
Loc.
No.
Part No. Part Type Software function
Burned before
SMT
Burning method
N103 5272564002
IC_EN25Q64-104HIP
FLASH Yes
Use ALL-100 with write-protect, refer
to Note 1 in detai
N106 5272404005
IC_CAT24C04WI-GT3
HDCP KEY Yes Use ALL-100, etc.
N301 5272402003
IC_CAT24C02WI
HDMI EDID Yes
Use ALL-100, etc.
N311 5272402003
IC_CAT24C02WI
HDMI EDID Yes
Use ALL-100, etc.
N305 5272402003
IC_CAT24C02WI
VGA EDID Yes
Use ALL-100, etc.
Note 1:
Method of write-protect setup: enter into burning interface of ALL-100, tick option “
Config
”,
press item “
config Setting
”, set option “
Protect
” as “
All Protect
”; make sure that option “
Config
”
must be ticked before burning software and write-protect must be reset after ALL-100 burning
software is opened every time.
Note 2:
Method of burning and upgrading software online by using ISP burning device:
a) For main board upgrade: connect 4-pin cable of ISP burning device to Debug port of main board
(
X107
); for the unit upgrade, connect both VGA ports of ISP burning device and main board,
enter into factory menu and set item “
Other Settings
->
ISP Mode
” as “
ON
”;
b) Using
Mstar
online burning program
(
V4.4.2.0
and higher versions
)
, enter into menu “
Device
”,
tick option “
WP Pin pull to high during ISP
” , ensure that hardware write-protect of Flash is
removed and erasing process is normal, please refer to Fig. 15;
Fig. 15 Write-protect setup
c) Press menu “
Connect
”, a dialog box “
Device Type is MX25L64
will pop up, that is, connection
has been successful, please refer to Fig. 16; if connection is failed, press the first menu “
Device
”
to select SPI Flash type “
MX25L64
” manually, then press menu “
Connect
” again;
Method of software upgrading
instructions