5
Need help?
http://ca.sanyo.com
1-800-263-2244
1
Remove the two (2) screws holding the stand
base cover and carefully dislodge.
STAND REMOVAL AND WALL
MOUNTING
(OPTIONAL)
Tools Needed:
Phillips screwdriver
IMPORTANT NOTE:
Place HDTV face down
on a padded or cushioned flat surface to
protect the screen and finish.
Wall mounting of the HDTV must be performed
by a skilled person.
GETTING STARTED
Install two (2) “AAA” batteries in the remote
control. (Not included)
To ensure safe operation, please observe the
following precautions:
•
Replace both batteries at the same time. Do not use a
new battery with a used battery.
•
There’s a risk of explosion if a battery is replaced by
an incorrect type.
•
Do not expose the Remote Control unit to moisture
or heat.
•
Be sure to match the
“+”
and
“
–
”
signs on the
batteries with marks inside the remote control.
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
ANTENNA
CABLE
ANALOG / DIGITAL
ANTENNA IN
BATTERY INSTALLATION
Hook up your antenna or your cable service to
the HDTV’s
ANT
terminal with the use of a 75
OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away
from the television set and any other electronic
equipment.
The tuner in this HDTV can receive
:
•
Digital and Analog off air signals from an antenna
•
Analog or ClearQAM cable channels from a direct
Cable TV connection.
2
Remove the four (4) screws securing the
stand base to the HDTV.
CAUTION:
Hold the
stand firmly as you remove the last screw.
3
Use the screws that are threaded into the four
(4) inserts on the back of your HDTV to secure
it to an appropriate wall mounting kit.
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter, Length—12mm (maximum)
NOTE: Wall mounting kit is not included.
