Sanyo LCD-22XR9DA, Service Manual

Page: 28 / 51

Trouble shooting
1. Fault clearance
Before servicing please check to find the possible causes of the troubles according to the table
below.
1.1 Antenna (signal):
Picture is out of focus or jumping z Bad status in signal receiving
z Poor signal
z Check if there are failures with the electrical connector or
the antenna.
z
Check if the antenna is properly connected.
Fringe in picture z Check if the antenna is correctly oriented.
z Maybe there is electric wave reflected from hilltop or
building.
Picture is interfered by stripe
shaped bright spots
z
Possibly due to interference from automobile, train, high
voltage transmission line, neon lamp etc.
z Maybe there is interference between antenna and power
supply line. Please try to separate them in a longer
distance.
z
Maybe the shielded-layer of signal wire is not connected
properly to the connector.
There appear streaks or light color
on the screen z Check if interfered by other equipment and if interfered
possibly by the equipment like transmitting antenna,
non-professional radio station and cellular phone.
1.2 TV set:
Symptoms Possible cause
Unable to switch the power on z Check to see if the power plug has been inserted
properly into the socket.
No picture and sound z Check to see if the power supply of liquid crystal TV has
been switched on. (As can be indicated by the red LED
at the front of the TV set)
z
See if it’s receiving the signal that is transmitted from
other source than the station
z Check if it’s connected to the wrong terminal or if the
input mode is correct.
z Check if the signal cable connection between video
frequency source and the liquid crystal TV set is correct.
Deterioration of color phase or
color tone z Check if all the picture setups have been corrected.
Screen position or size is not
proper
z Check is the screen position and size is correctly set up.
Picture is twisted and deformed z Check to see if the picture-frame ratio is properly set up.
Picture color changed or colorless z Check the “Component” or “RGB” settings of the liquid
2
6