PRECAUTIONS FOR HANDLING DISCS
INSTALLATION PARTS
T h e s y m p t o m s d e s c r i b e d b e l o w s o m e t i m e s
occur when new discs are used.
l
The disc is not played even when it is
loaded.
l
Operation changes to the next disc
before the first disc has a chance to be
played.
l
The same disc is played over and over
again.
l
The designated disc is not played.
These symptoms occur when there are
burrs on the
hole or outside circum-
ference of the disc and, as a result, the disc
has not been loaded properly or the disc
catches on something inside the magazine.
In cases like these, remove the burrs using
a ball-point pen or similar implement, as
shown in the figure on the right.
n
With new discs
/ c i r c u m f e r e n c e
Remove all plastic particles
of burr
from
surfaces of disc before loading
in magazine.
With 8 cm CDs
When using 8 cm CDs, use a 8 cm CD
adapter which conforms to CD standards
and be sure to load the CDs in trays No. 1,
3, and 5 (gray trays). Loading CDs into
other trays will result in a malfunction.
Be sure to attach the disc properly to the
catches provided on the adapter. If the
disc is not attached correctly, it may come
free inside the magazine or play mecha-
nism, rendering the unit inoperable.
Storing the 8 cm CD adapters
Under no circumstances must an empty
8 cm CD adapter be loaded inside the
magazine.
If this warning is not heeded,
the adapter will remain inside the mecha-
nism, rendering the unit inoperable.
WARNING
n
Although protective film is being marketed
a s C D a c c e s s o r i e s , u s e o f t h e s e p r o d u c t s
will result in malfunctions and should
absolutely be avoided.
8 cm CD Adapter
adapter
8 c m
C D ’
Empty 8 cm CD adapter
Bracket (L)
Bracket (R)
Bracket
Hexagonal bolt
Hexagonal bolt
Nut
x
with washer
(M5 x
x 2
x 4
x 4
x 4
Tapping screw
( M 5 x 1 . 2 )
x 4
D I N 8
pin
Seal
Double
sided tape
ID (Identity) SWITCH FOR CD CHANGER
ID switch
By using the separately sold Divider unit
an additional CD changer
(FXD-Cl00 or FXD-C200) can be installed. When an additional CD changer has
been attached in this fashion, the ID switch is used to indicate the number of each
respective changer unit.
l
When changer is used independently
* The ID switch is initially set to
when shipped.
l
When changer is used as additional changer unit
1st
unit
2nd unit (additional changer unit)
* Use a ballpoint pen or similar fine-tipped implement to change the orientation of
the switch.
