Sanyo EM-C2001SD, Service Manual

Page: 13 / 28

- 12 -
Figure 11
NOTES
- When removing the magnetron, make sure that its
dome does not hit any adjacent parts, or it may be
damaged.
- When replacing the magnetron, be sure to install the
magnetron gasket in the correct position and be sure
that the gasket is in good condition.
- After replacing the magnetron, check the microwave
energy leakage to ensure it is below the limit of
5mW/cm
2
.
Duct,rear
Duct, front
Exhaust duct
front
Magnetron
front
Exhaust duct
front
Magnetron
front
Blower Ass’y
rear
Blower Ass’y
front
Stay
HOW TO RESET THE MEMORY OF
ACCUMULATIVE COOKING TIME:
Note; Total number of door operation can not be
cleared.
When new magnetron is replaced, accumulative
cooking time must be set to “Zero” as follows.
(1) Touch “C” key. The “0” appear on the display/
(2) Touch “Clock mark” key. The colon and power
level ten bar will appear on the display.
(3) Touch number key “8” three times. The “8.88”
will appear on the display.
(4) Continuously touch coursse key “1”. “88.81” will
appear on the display.
(5) Touch “Start” key. All four digit will be flashing.
(6) Touch “Start” key again. The displayed number
shows the accumulative cooking time.
(7) Touch “0” and “Memory” key. Accumulative
cooking time will be cleared.