1-5: DVD MT PCB and DVD DECK (Refer to Fig. 1-5)
1-6: POWER PCB (Refer to Fig. 1-6)
1. Put the Cabinet Back Ass'y on the bottom.
1. Disconnect the following connectors:
2. Short circuit the position shown in Fig. 1-5 using a
(CP3001 and CP3002)
.
soldering iron. If you remove the DVD Deck with no
2. Remove the 2 screws (1).
soldering, the Laser may be damaged.
3. Remove the Sheet PC in the direction of arrow (A).
3. Disconnect the following connectors:
4. Remove the 4 screws (2).
(CP2301, CP2302, CP2303, CP8501 and CP8502).
5. Remove the Power PCB in the direction of arrow (B).
4. Remove the 3 screws (1).
5. Remove the DVD DECK Ass'y in the direction of
arrow (A).
6. Remove the 4 screws (2).
7. Remove the Shield LVDS in the direction of arrow (B).
8. Remove the Shield LVDS Bottom in the direction of
arrow (C).
9. Unlock the 2 supports (3).
10. Remove the DVD MT PCB in the direction of arrow (D).
DISASSEMBLY INSTRUCTIONS
(1)
(1)
Power PCB
(A)
(2)
(2)
(B)
Back Cabinet Ass'y
(2)
Sheet PC
(1)
DVD MT PCB
(1)
(D)
(B)
(2)
DVD Deck
Pick Up PCB
(2)
(1)
(3)
(2)
(2)
(2)
(C)
Shield LVDS
B1-2
1-7: DIGITAL PCB (Refer to Fig. 1-7)
1. Disconnect the following connectors:
(CP301, CP6202 and CP6204)
.
2. Remove the 7 screws (1).
3. Remove the Digital PCB in the direction of arrow.
NOTE
1. Before your operation, please read "PREPARATION
OF SERVICING".
2. Use the Lead Free solder.
3. Manual soldering conditions
• Soldering temperature: 320 ± 20
o
C
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux
smoke away from it.
5. When installing the DVD Deck, remove all the soldering
on the short circuit position after the connection of Pick
Up PCB and DVD MT PCB connector.
(1)
(1)
Digital PCB
Back Cabinet Ass'y
Fig. 1-7
Back Cabinet Ass'y
Fig. 1-6
(1)
(1)
(1)
(1)
(1)
(A)
Fig. 1-5
Back Cabinet Ass'y
Short circuit using a
soldering iron.
Shield LVDS Bottom
B1-2
