-10-
INFORMATION
PROBLEM
POSSIBLE CAUSE
REMEDY
No Sound
Volume is too low.
Power cord incorrectly
connected.
Increase volume
Connect power cord correctly.
The device does not
respond to button
commands
Electrical static discharge. Switch off the
device,disconnect the mains
cable and plug it in again after
a few seconds.
Poor radio reception Weak radio signal
FM: Extend the FM antenna to
its full length or try to change
the postion and direction of
the FM antenna.
AM: Change the position of
the unit until it picks up the
strongest signal.
Interference from
electrical devices such as
televisions,video recorders,
computers,neon lamps,etc.
Move the unit away
from the other operating
electrical equipments such
as motorized appliances,
televisions, and microwave
ovens.
Troubleshooting
If a fault occurs, first refer to this information before you take the device for repair.
If you are unable to rectify the fault using the information given here, contact
Customer Support for advice.
Under no circumstances should you attempt to repair the device yourself, as this
would invalidate the warranty.
SPECIFICATIONS
Power:
AC 240 V ~ 50 Hz
AM :
530 - 1600 kHz
FM:
88 - 108 MHz
DC Backup :
9V (6F22 9Vx1)
Unit output power:
1 x 0.5 W
Power Consumption : 13W
Measurement:
160(L) X 125(W) X 69(H)mm
Weight:
0.67 KG
Summary of Contents for DMP-P3
Page 1: ...DMP P3 Clock Radio for iPod ...
Page 7: ...OVERVIEW FRONT VIEW TOP VIEW 5 REAR VIEW ...
Page 8: ... 6 BOTTOM VIEW SIDE VIEW ...
Page 14: ...309 031750 0001 ...