Sanyo CR21KX2, Service Manual

Page: 7 / 30

-7-
IC Block Diagrams
IC501 < Vertical Output > LA78040/TDA9302H
Thermal
Protection
-
+
AMP
Pump
Up
1
INVER
TING
INPUT
2
Vcc
3
PUMP UP OUT
4
GND
5
V
e
r.
OUTPUT
6
OUTPUT ST
A
GE Vcc
7
NON INV
.
INPUT
IC001 < Audio AMP.> AN5274
Volume
Ripple
Filter
Over
Current
Thermal
Protection
Circuit
+
-
+
-
1
2 3
4 5
6
7
8
9 10
11 12
Mute Control
Ch.1 Input
V
olume Control
Ripple Rejection
Ch.2 Input
Ripple Filter Ch.2 Output
Negativ
e
F
eedbac
k Ch.2
GND
Vcc
Negativ
e
F
eedbac
k Ch.1
Ch.1 Output
Service Information
This TV set has a built-in power supply protection circuit.
It is provided to protect the TV set in case of a power supply circuit malfunctions. When something abnormality
occurs during TV reception, the TV set goes to the stand-by mode.
When an abnormality occurs during TV reception, it causes pin 27 of the CPU to go continually Low(less than
0.75V) for about one second. The CPU detects that this has occurred and outputs the signal from pin 31 to
switch off the power supply lines.
Releasing the protective circuit and restoring power supply
To release the protective circuit and restore power supply, turn the power to the TV set OFF and then ON again
via either the main power switch or the ON-OFF button on the remote control. This will work only if the power
supply trouble was temporary. If there is permanent trouble such as a damaged circuit, power cannot be
restored and the circuit will have to be repaired.
■
Protection Circuit