Sanyo CE42SRE1, Instruction Manual

Page: 10 / 64

10
Common specification
Power source 220~240V 50Hz
Colour system PAL NTSC3.5 ,SECAM
AV terminal
AV1: Scart CENELEC Standard
Input: Composite video, RGB (5V RGB with 5V sync to
pin 14) and audio-L/R
AV2: BNC
Input: RGB, H and V / Y, Pb, Pr and audio L/R
Output: RGB, H and V / Y, Pb, Pr
AV3: BNC
Input: Composite video
Output : Composite video
Audio Monitor.Out: CINCH L/R
Audio Speaker out: 2 x 6W
DVI Input : DVI-D GROUP Standard
PC Input: Mini D-SUB 15 PIN and
Audio 3.5mm Jack
Serial port: RS232C: Input/Output
Contrast Ratio 1000:1
Screen(inches/ cm) 42” / 107 cm
(viewing measured
diagonally)
Display Native Resolution 1366 x 768 (WXGA)
Viewing angles H:178°, V:178°
Dimensions (WxHxDmm) 1032x 625x126.5 (without stand)
1032 x 683 x 340 (with stand)
Weight (kg) 20 (without stand)
21 (With stand)
■ NO PICTURE, NO SOUND
● Check if monitor is plugged in.
●
Check monitor is not in standby mode
■
POOR PICTURE, SOUND OK
●
Adjust BRIGHTNESS/ CONTRAST LEVELS (too low).
■
NO COLOUR, PICTURE OK
●
Adjust COLOUR control.
● Check lead connections
●
Does the signal input have colour
■ REMOTE CONTROL DOES NOT WORK
● Check batteries are inserted correctly
● Check condition of batteries
●
Check to see if remote control inhibit is set ON
■
PICTURE OK, NO SOUND
● Check external speakers are connected correctly
●
Check lead connections to external equipment
● Volume turned down or mute selected
GB GB
Specification
Helpful hints