General Operation
■
If no operation is performed after the TV has
been switched on by the ON TIMER, such as
if you are not at home, the TV will be
automatcally switched off after approximately
2 hours.
■
If the TV is already switched on when the time
set for the ON TIMER has been reached, only
the programme position will be changed to the
set programme position.
■
Cancelling ON TIMER. To cancel the ON
TIMER, press the
VOLUME
(
+
or
-
) button to
set it to “ON 0:00” while the ON TIMER screen
is shown. Switching off the TV by pressing the
Mains ON/OFF
button will also cancel the
ON TIMER settings.
■
The OFF TIMER cancels when the TV set is
turned off or if a power failure occurs.
The OFF TIMER will switch off the TV automatical-
ly after 30 minutes, 1 hour, 1 hour and 30 minutes,
or 2 hours.
1
Press the
TIMER
button.
2
Press the
VOLUME ( +
or
-
) button to select
the time period.
OFF 0:00
■
Just one minute before switching off the TV,
“OFF 0:01” will be display on the screen.
■
To cancel the OFF TIMER, select “OFF 0:00”
by pressing the
VOLUME (+
or
- )
button.
When the ON TIMER is set. TV will automatically
be switched on to the selected programme position
when the specified time has elapsed.
1
Press the
TIMER
button twice.
(ON TIMER setting
mode)
ON 0:00 2
Programme position for when TV is
switched on by ON TIMER.
2
Press the
VOLUME ( +
or
-
) button. The set
time will be increased or decreased by 10
minutes each time the button is pressed ; the
maximum time which can be set is 24 hours.
OFF TIMER
ON TIMER
3
Use Direct programme Selection to insert pro-
grammme position for when TV is switched
on by ON TIMER. (see page 6.)
Colour and Sound System
6
AUTO
6
PAL
6
NTSC4.43
6
NTSC
Normally, set the colour system to “AUTO”, if the
clear picture cannot be obtained even when the
broadcasting or AV signal is received, press the
RECALL/COLOUR SYSTEM
button repeatedly
until the optimum image can be produced.
(Refer to
Broadcast Transmission System List
indicated by the last of this page in a setup of
Colour System.)
Each time the
RECALL/COLOUR SYSTEM
but-
ton is pressed, colour system changes as follows;
Setting of the Colour System
To set the sound system, make it during Semi-Auto
Tuning or Manual Tuning mode.
When the sound is not clear or no sound is pro-
duced on a programme number position, select
sound system repeatedly until the optimum sound
is obtained.
(Refer to
Broadcast Transmission System List
indicated by the last of this page in a setup of
Sound System.)
Setting of the Sound System
To select sound system:
■
Press the
SOUND SYSTEM
button to select
the sound system directly. The sound system
will be memorized automatically.
7
inst. BA3D -A(MYS& AUS) 3/28/07 3:00 PM Page 7
