Sanyo CA14G1C, Instruction Manual

Page: 8 / 20

8
General Operation
Press the PICTURE MODE button to select
the following picture modes; “ PERSONAL ”,
” DYNAMIC ”, ” NATURAL ”, “ ECO ” and
“ GAME ”. Select picture modes to suit picture
type you are watching.
Quick Picture Controls
-/- -
-/- - -/- - -/- -
-/- -
-/- -
-/- -
PICTURE
■
The OFF TIMER cancels when the TV set is
turned off or if a power failure occurs.
The OFF TIMER will switch off the TV automatical-
ly after 30 minutes, 1 hour, 1 hour and 30 minutes,
or 2 hours.
1
Press the TIMER button.
2
Press the VOLUME ( + or - ) button to select
the time period.
OFF 0:00
■
Just one minute before switching off the TV,
“OFF 0:01” will be display on the screen.
■
To cancel the OFF TIMER, select “OFF 0:00”
by pressing the VOLUME (+ or - ) button.
OFF TIMER
When the ON TIMER is set. TV will automatically
be switched on to the selected programme posi-
tion when the specified time has elapsed.
1
Press the TIMER button twice.
(ON TIMER setting mode)
ON 0:00 2
Programme position for when TV is
switched on by ON TIMER.
2
Press the VOLUME ( + or - ) button. The set
time will be increased or decreased by 10
minutes each time the button is pressed ; the
maximum time which can be set is 24 hours.
ON TIMER
■
If no operation is performed after the TV has
been switched on by the ON TIMER, such as
if you are not at home, the TV will be auto-
matically switched off after approximately 2
hour.
■
If the TV is already switched on when the time
set for the ON TIMER has been reached, only
the programme position will be changed to the
set programme position.
■
Cancelling ON TIMER. To cancel the ON
TIMER, press the
VOLUME ( + or - ) button to
set it to “ON 0:00” while the ON TIMER screen
is shown. Switching off the TV by pressing the
Mains ON/OFF button will also cancel the
ON TIMER settings.
3
Use Direct programme Selection to insert pro-
grammme position for when TV is switched on
by ON TIMER. (see page. 7)
Press the ALTERNATE button, and the pro-
gramme position will alternately select the
previous position and the present position.
-/- -
-/- - -/- - -/- -
-/- -
-/- - P P
-/- -
ALTERNATE
Colour and Sound System
6
AUTO
6
PAL
6
NTSC4.43
6
NTSC
Normally, set the colour system to “AUTO”, if the
clear picture cannot be obtained even when the
broadcasting or AV signal is received, press the
RECALL/COLOUR SYSTEM button repeatedly
until the optimum image can be produced.
(Refer to
Broadcast Transmission System List
indicated by the last of this page in a setup of
Colour System.)
Each time the RECALL/COLOUR SYSTEM but-
ton is pressed, colour system changes as follows;
Setting of the Colour System
To set the sound system, make it during Semi-
Auto Tuning or Manual Tuning mode.
When the sound is not clear or no sound is pro-
duced on a programme number position, select
sound system repeatedly until the optimum sound
is obtained.
(Refer to
Broadcast Transmission System List
indicated by the last of this page in a setup of
Sound System.)
Setting of the Sound System
inst. manual-C5SWC (mono) 8/4/05 11:34 AM Page 8