●
You can charge the battery with turning the power ON, but it will take longer.
●
If the battery has not been used for a long period or not charged for some time after sounding the alert
tone, it may not start charging. When the battery pack is still usable, the reception lamp lights up in a
couple of minutes and the "
" also lights up to start charging.
●
When you charge the battery in weak signal areas, it might take time for the light (of incoming /
charging) to light up after you set the phone into the desktop charging holder.
●
When installing the phone into the desktop charging holder, do not move the phone around while it is
in the holder. Failure to do so will cause a damage of the phone or poor contact with the holder.
●
After charging, pull out the connector by pushing release buttons on the both sides.
●
Using the desktop holder, the phone transmits the data even while being charged.
1. Insert the connector of the Sanyo AC adapter 02 firmly into the desktop
charging holder.
2. Connect the plug of the Sanyo AC adapter 02 into an AC wall outlet.
3. Put the telephone (A1303SA) with battery pack attached into the desktop
charging holder, paying attention to the installing direction.
Install the body securely onto the charging holder and make sure that the
light (of incoming call / charging) lights up in red.
Charging time:
approximately 100
minutes.
1
Charging with the Sanyo AC Adapter 02
Getting Ready to Make a Call
While charging
Fully charged
Light
lights up in red
lights up in green
Display / sub-display
"
" or "
" appears
Phone power is ON → The "
" appears
Phone power is OFF → Disappears
4. When fully charged, remove the phone (A1303SA) from the desktop charging
holder, then disconnect the plug from the AC wall outlet.
④
③
②
①
Light
(lights up in red)
au telephone
(with battery
pack attached)
Desktop charging holder
Sanyo AC adapter 02
AC wall outlet
7
