SY265C LC/SY265C LR Excavator OMM
5-56
Operation and Maintenance Manual — 0420
SANY
Fuel System
Check the Fuel Lines
Inspect all fuel lines and hoses on the machine and the engine. Replace as necessary.
Drain the Fuel Tank
1. Park the machine on a flat, level surface and position
the upper structure to allow access to the right cover
plate under the fuel tank.
2. Prepare the machine for service. See “Maintenance
3. Open the right rear access door. See “Right Rear
4. Unlock and remove the fuel tank filler cap (1). See
“Fuel Tank Filler Cap” on page 4-12.
5. Direct the drain tube (3) from the fuel tank down
through the floor grating.
6. Place an appropriately sized container under the end of
drain tube. See “Capacities” on page 5-14 for more
information.
7. Open the drain valve (2).
8. Close the drain valve when the fuel flow stops.
9. Add fuel to the system as necessary.
10. Install and lock the fuel tank filler cap.
11. Start the engine and allow it to run at low idle.
12. Check for leaks in the fuel system, repair as necessary.
13. Close and lock the right access door.
NOTICE!
Dispose of contaminated fuel in accordance
with local environmental regulations. Failure to
do so could damage the environment.
Fig. 5-64
1
0004153
Fig. 5-65
0005327
3
2
Summary of Contents for SY265C LC
Page 2: ...Page Intentionally Blank ...
Page 287: ...Page Intentionally Blank ...
