SY265C LC/SY265C LR Excavator OMM
4-12
Operation and Maintenance Manual — 0420
SANY
Closing the Engine Compartment Door
Move the support rod out of the slot in the support bracket to close the access door. Pull the door down and hook
each door latch onto the door. Secure each door latch by locking them. See “Door Support Rod” on page 4-7.
Fuel Tank Filler Cap
Remove the Fuel Tank Filler Cap
1. Slide open the lock shield (1) on the fuel tank filler cap
(2).
2. Insert the key into the lock.
3. Turn the lock and key clockwise from the locked
position (3) to open position (4) and remove the fuel
tank filler cap.
•
Lock position (3)
•
Open position (4)
Install the Fuel Tank Filler Cap
1. Install the fuel tank filler cap (2) onto the filler tube.
2. Insert the key into the lock.
3. Turn the key from the open position (4) counterclockwise to the lock position (3).
4. Remove the key.
5. Close the lock shield (1).
NOTICE!
•
Make sure the O-ring on the fuel tank filler cap is clean. If the O-ring is contaminated by
dirt or debris, it could be damaged and not seal properly.
•
Inspect the O-ring for wear or damage. Replace if necessary.
•
Make sure the fuel tank filler cap is fully seated before turning the key to lock or open the
cap.
•
Close the lock shield when not in use to prevent dirt and debris from entering the lock.
Failure to follow this notice could damage the machine or cause it to operate improperly.
Fig. 4-15
0003.017
4
3
2
1
Summary of Contents for SY265C LC
Page 2: ...Page Intentionally Blank ...
Page 287: ...Page Intentionally Blank ...
