SY265C LC/SY265C LR Excavator OMM
4-46
Operation and Maintenance Manual — 0420
SANY
MANUAL REGENERATION
1. Prepare the machine for service. See “Maintenance
2. Make sure the machine has an adequate amount of
DEF fluid (1) and enough fuel (2) as shown by the
gauges on the monitor home screen.
3. Start the engine and park the machine in a safe location
where the exhaust pipe will not face any combustible
surface. See “Starting the Engine” on page 4-25.
4. Move the hydraulic lockout lever (3) into the locked
(closed) position (4) and run the engine at low idle. See
“Hydraulic Lockout Control Lever” on page 3-5.
NOTE:
Make sure the DPF regeneration icon is
illuminated. The illuminated icon indicates
that manual regeneration is permitted. See
“Home Screen Function Icons and Buttons”
on page 3-38.
WARNING!
•
The exhaust temperature during diesel particulate filter (DPF) manual regeneration can
reach approximately 1100°F (600°C). Make sure there are no flammable materials around
the exhaust system or machine. Do not touch any part of the exhaust system.
•
Exhaust gas contains carbon monoxide. Carbon monoxide is an invisible and odorless
gas, and is toxic. Operate the engine only in a well-ventilated area.
Failure to follow these warnings could result in death or serious injury.
NOTICE!
When performing diesel particulate filter (DPF) manual regeneration, start the engine and
allow it to warm to an operating temperature of 104°F (40°C). Do not start the regeneration
process before the engine is at operating temperature. Failure to follow this notice could
damage the machine or cause it to operate improperly.
100%
Fig. 4-63
0004797
2
1
Fig. 4-64
0005234
3
4
Summary of Contents for SY265C LC
Page 2: ...Page Intentionally Blank ...
Page 287: ...Page Intentionally Blank ...
