— 11 —
[5] MEASURING PROCEDURE
5-1 Start-up Inspection
Check the following items before proceeding to measurement.
t &YUFSJPS DIFDL $IFDL UIF FYUFSOBM WJFX GPS JSSFHVMBSJUZ DBVTFE CZ
ESPQQJOHFUD
t $IFDL UIBU UIF CBUUFSZ BMBSN
JT OPU MJU *G JU JT MJU SFQMBDF UIF
batteries with new ones.
t"DDFTTPSJFT$IFDLUIBUUIFUFTUMFBETBSFGSFFPGJSSFHVMBSJUZTVDIBT
wire disconnection or crack.
t4FUUIFGVODUJPOTXJUDIUP
and short the test pins to check that
the test leads are free of wire disconnection.
t.BLFTVSFUIBUUIFNBJOVOJUBOEIBOEBSFOPUXFUXJUIXBUFSFUD
*GUIFEJTQMBZTIPXTOPUIJOHUIFCBUUFSJFTNBZCFFYIBVTUFEDPNQMFUFMZ
5-2
Auto low-impedance voltage/resistance detecting
NFBTVSFNFOU "VUPût7
1. Do not apply an input signal exceeding the maximum rated value
of each function.
%VSJOHNFBTVSFNFOUEPOPUDIBOHFUIFGVODUJPOTXJUDI
%VSJOHNFBTVSFNFOUEPOPUUPVDIUIFUFTUQJOTJEFPGUIFCBSSJFS
of the test probe or the part past the barrier of the clamp sensor.
8IFO NFBTVSFNFOU JT GJOJTIFE SFNPWF UIF DMBNQ TFOTPS $5
and test lead from the object measured and return the function
switch to the
position.
5. Use test leads matching the measurement category of the
measured point.
"TUIFJOJUJBMJOQVUJNQFEBODFJTBTMPXBTLûBIJHIDVSSFOU
GMPXT UISPVHI UIF NFBTVSFE DJSDVJU XIJDI NBZ FYFSU BEWFSTBSZ
effects in measurements of a circuit with ground-fault interrupter
or circuit/device with low current capacity. When measuring a
WPMUBHFUIBUSFRVJSFTIJHIJOQVUJNQFEBODFCFTVSFUPVTFUIF
or
function.
'PS FYBNQMF UIF JOJUJBM NBY MPBE DVSSFOU JO "$ 7
NFBTVSFNFOUJTIJHIBUN" 7YLûCVUUIF
internal resistance is switched immediately so the load current
ESPQTUPBCPVUN" 7¨Lû
WARNING
WARNING
Summary of Contents for DCM2000DR
Page 1: ...DCM2000DR DIGITAL CLAMP METER INSTRUCTION MANUAL ...
Page 33: ...MEMO ...
