1-888-726-8869 www.sanuvox.com
Sanuvox Technologies INC. All rights reserved. 2019-v.1
INSTALLATION MANUAL
Inlet Collar (left side)
Remove
access door
to the UV
Lamp(s)
Outlet Collar (right side)
STEP 1
Install Inlet / Outlet Collars (each collar is a set of 2 x 8” round inlet and outlet)
Open the access door and insert the two pairs of collars into the SANUVAIR® S1000. Align the holes and screw down
each pair of collars from the top of the SANUVAIR® S1000 with the included philips screws (6 screws per collar). Pay
special attention to the orientation of the notch on the right side collar.The notch (highlighted in black) should be pressed
up against the right side of the SANUVAIR® S1000.
STEP 2
Installation of the UV Lamp
The UV Lamp is to be installed in the Aluminum Reflecting Chamber. To slide out the Aluminum Chamber, remove the two
butterfly bolts and screws which secure it in place.
* A clamp (or two, if you ordered an optional second lamp) is there to hold the lamp(s).
MAKE SURE TO PUT THE RIGHT LAMP IN THE RIGHT CLAMP (see label identifier).
Adhere the included foam gasket (included
in the Lamp box) to the porcelain end-cap
with the 4 pins.
Insert the end-cap with foam gasket into the
clamp assembly and tighten. Be careful not to
over tighten as it may result in end-cap breaking.
Insert the white-plug into the UV Lamp’s 4
pins. The plug will only fit in two of four ways.
Either way is fine. The exposed wire-set is
Teflon coated and is resistant to UV exposure.
