6902-002023 <00>
7
[01]
3
Mount the Wall Plate
Wood stud
5.5mm
(7/32 in.)
13 mm
(1/2 in.)
3-1
Locate studs
3-2
Mark the wall
Level the wall plate
[01]
and mark the hole locations.
3-3
Drill pilot holes
3-4
Tighten lag bolts
CAUTION:
Avoid potential injuries or property damage! Pilot
holes
MUST
be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
CAUTION:
Avoid potential injuries or property damage!
Improper
use
could
reduce
the
holding
power
of
the
lag
bolt.
To
avoid
potential
injuries
or
property
damage
Ù
DO NOT
over-tighten the lag bolts
[04]
.
Ù
Tighten the lag bolts
[04]
only until the washers
[05]
are
pulled fi rmly against the wall plate
[01]
.
[01]
[04]
[05]
41- 61cm
(16-24 in.)
< 16 mm
(5/8 in.)
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Ù
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in).
75 mm
(3 in.)
