Sanus BMT1, Instruction Manual

Page: 23 / 48

23
Steel Stud Anchor Kit [NOT INCLUDED]
1/4-20 x 1.75
1/4-20 Snap Toggle BB
.734 x .312 x .065 in.
Min. 16 in.
(406 mm)
CAUTION
: Avoid potential personal
injuries and property damage!
●
Studs must be at least 2x4 / 25 ga.
●
If back side of wall is unfinished, drywall
must be installed to a minimum of one stud
left and right of the stud(s) being used to
install the mount.
● Drywall must be a minimum of 1/2 in. (13mm)
thick on each side of the studs, and a
minimum clearance of 1 7/8 in. (48 mm)
behind the wall is required.
●
This product must be centered on the studs.
●
Stud type and structural strength
must conform to the North American
Specification for the Design of Cold-Formed
Steel Structural Members
[362 S 125 18, C-Shape, S - Stud Section].
●
Drywall must be secured to studs with
screws 12 in. (304.8 mm) on center.
STEP 2D Steel Stud Option (Double and Single Stud Install)
S1 x4
S2 x4
S3 x4
Screw
Washer
Anchor
Contact Customer Service at
1-800-359-5520 to have this
additional hardware shipped
directly to you.
1 2 3
1. Locate the studs using a stud finder.
2. Find the edges of the studs using an awl or small drill bit.
3. Mark the centers of the studs with a pencil.