11
Cleaning with Foam extraction system
NS270BRUSH can be connected to a foam extraction machine (Sabrina Foam, HOT Sabrina Foam), to
clean carpet with foam extraction system.
With this system, it is possible to spray on carpet a special dense foam, which is brushed afterwards,
incorporating the dirt. After some seconds the foam is vacuumed from carpet, using the same accessory.
Carpet will be dry in a particularly short time.
NS270BRUSH can be used both with injection-extraction system or with foam extraction system,
according to the machine to which it is connected, the area to be cleaned and t
he operator’s
preferences.
To work with foam extraction system, proceed as follows:
1. replace the 3 spraying nozzles and use the special nozzles (with a larger hole), which are
supplied with NS270BRUSH.
2. put the solution regulation valve in horizontal position (maximum flow).
Maintenance
NS270BRUSH is a device designed for professional use. The warranty on these machine is of 1 year
and regards the faults due to manufacturing defects. The faults due to improper use are not covered by
warranty. For further details regarding warranty, contact the distributor supplying the machine.
For a good preservation and a long duration of the machine, observe the following advice:
1. Periodically check that the brush can rotate without problems and eliminate any cause that avoid
its free rotation. In case of problems, contact an after sales centre.
2. It the brush is worn out, it is possible to replace it with a new one.
3. Periodically check that the spray nozzles are clean, so that the solution is sprayed uniformly on
carpet. In case of dirty nozzles, it is enough to remove them and clean them under water, using a
little brush.
