
6
The choice depends on the status of the carpet and the time available for cleaning.
In any case, it is always recommended to perform cleaning with clean water only, in order to
rinse the carpet surfaces.
Rinsing is important to eliminate the chemical residual from textiles and ensure that carpet
will re-soil slowly after cleaning, just as it happens with a new carpet.
If rinsing is not preformed, the chemical residual left on carpet may reduce the time after
which carpet is dirty again.
STEP C
– EXTRACTION CLEANING WITH CLEAN WATER ONLY
•
Check on the regulation panel that the chemical input valve is closet.
•
Proceed with extraction cleaning, using the carpet wand and spraying clean water only.
NOTE:
After switching OFF the pump, it is necessary to discharge the pressure in the circuit,
by pressing the spraying lever on the accessory. If this operation is not performed, the pump
might have difficulty and not be able to start when its switch is pressed again in the ON
position.
NOTE:
The capacity of the recovery tank is enough to vacuum all the liquid previously
sprayed with a full tank of the clean water tank. After vacuuming the residual liquid, do not
re-fill the clean water tank before draining the recovery tank. Furthermore, avoid to vacuum
liquid not sprayed by the same machine, but for example by other sources. In this case in
fact the quantity of water vacuumed into the recovery tank could be excessive for its
capacity. If this should happen, check often the level of the recovery tank.