0 2
S p o u t
Spout Installation
Remove tee connector, tee connector washer, lift rod,
and spout mounting hardware from bottom of spout
assembly. Apply a ring of silicone caulking around the
center hole on the top of the sink (do not use plumber’s
putty which can damage the spout
fi
nish).
From the top of the deck, drop in the spout
through the center hole of the sink or
counter surface.
Hole size for the spout and handle trim is a minimum of 1
¼
” and a maximum of 1
½
”.
Flush both supply lines before installation. After
fl
ushing, shut o
ff
both supply lines.
Lift Rod
Notched rubber washer
Tee connector
& Washer
Notched metal washer
Wing nut
Brass lock nut
Rubber
washer
A
Slip the spout mounting hardware back onto the spout.
First the notched rubber washer, then the notched metal
washer, (making sure the notch faces towards the back)
wing nut, and brass lock nut. Insert lift rod and make sure
it operates smoothly.
Adjust if necessary and remove the lift rod from the spout.
Hand tighten the nut.
washer, (making sure the notch faces towards the back)
wing nut, and brass lock nut. Insert lift rod and make sure
it operates smoothly.
Adjust if necessary and remove the lift rod from the spout.
Hand tighten the nut.
B
Wing nut
Align spout and secure to the sink or counter surface by
tightening the 2 screws on the wing nut with a Phillips
head screwdriver.
Place the tee connector washer into the tee connector
and thread the tee connector onto the end of the spout
shank. Hand tighten to seal.
C
(PLACE LIFT ROD ASIDE UNTIL POP-UP INSTALLATION)
