background image

 
make the plug fit onto your outlet.  This defeats the safety feature and could expose you to 
electric shock. 

 

 
 
 
 

 
 
 

PREPARATION FOR USE 

 
UNPACKING AND SET UP 

 

Remove any descriptive labels or stickers on the front or top of the cabinet. Do not 
remove any labels or stickers from the back or bottom of the cabinet.  

 

Note the serial number on the bottom of your radio and write this number in the 
space provided in page 3 of this manual. 

 

Place your clock radio on a level surface such as a table, desk or shelf, convenient 
to an AC outlet, out of direct sunlight, and away from sources of excess heat, dirt, 
dust, moisture, humidity, or vibration. 

 

Unwind the AC power cord of the radio and extend it to its full length. The FM 
antenna is built-in to this cord. It must be fully extended to provide the best FM 
reception. 

 

BATTERY BACK UP SYSTEM 

The battery back up system in this clock radio will maintain the time and alarm settings 
in the event of a temporary power interruption. When the AC power is restored the time 
and alarm settings will be correct. If the AC power is off at your wake up time, the back 
up system will use the battery power to turn on the radio or buzzer alarm as usual, as 
long as the back up battery is installed and has sufficient power remaining. 
 
The battery back up system requires one 9-volt battery (not included). 
We recommend that you install an alkaline battery for longest life and best performance. 

                  
 
 
 

 
 
 
 
 
 

 

TO INSTALL THE BATTERY 
 

 

Open the battery compartment cover on the bottom of the 
radio by pressing the tab in the direction of the arrow. 

 
 

 

Connect the 9-volt battery to the battery clip. It can only be 
connected one way. 

 
 

 

Push the battery into the battery compartment and replace 
the cover. 

 

 
 

BATTERY CARE 

i. 

Use only the size and type of batteries specified.  

ii. 

If the unit is not to be used for an extended period of time, remove the batteries. Old 
or leaking batteries can cause damage to the unit and may void the warranty.  

iii.  Do not try to recharge batteries not intended to be recharged; they can overheat 

and rupture. (Follow battery manufacturer’s directions).  

iv.  Do not dispose of batteries in fire, batteries may leak or explode.  

 
POWER FAILURE INDICATOR 

If there is no battery installed in the radio or the battery installed is weak or dead, the 
time and alarm settings will be lost if the power is interrupted. When the AC power is 
restored the clock display will begin flashing. This indicates that the time displayed is 
incorrect and needs to be reset. 
 

IMPORTANT: 

After you reset the time, be sure to reset your alarm settings as well. 

 
 
 

 
 
 
 
 
 
 
 
 
 
 

- 5 - 

- 4 - 

Summary of Contents for Hello Kitty KT2052







Reviews: