SanRex SANARG 200AP, Operator'S Manual

Page: 47 / 90

47
4.6 PARAMETER SELECTION
The Table below provides information of the parameters that are available for
modification using the front panel display. The table also provides information on the ranges
available for each parameter as well as to which weld process the parameter is available.
*1 : The values listed in the “Default” column are the “Factory Default Settings”. Once these are
changed, the last setting(s) before the unit is turned off will remain in memory for the next turn
on. These NEW settings will become the new default setting. The user must manually adjust
the setting to the values in the above chart to return to the “Factory Default Settings”.
*2 : Pulse frequency units are dependent on frequency setting range as shown below:
Setting range Units
0.5 to 20 Hz 0.1Hz
20 to 100Hz 1Hz
100 to 500Hz 5Hz
TABLE 4-3 : Front Panel Parameter Selection Ranges.
Process
PARAMETER RANGE Default *1 Units STK LFT HF
200AP
AC Frequency 15 to 150Hz 60Hz 1Hz YES YES YES
Wave Balance 10 to 65% 20% 1% YES YES YES
Weld Current (STICK) 5 to 160A 80A 1A
YES YES YES
Weld Current (TIG) 5 to 200A 80A 1A
YES YES YES
Pulse Base Current 5 to 200A 80A 1A
NO YES YES
Pulse Peak Current 5 to 200A 120A 1A
NO YES YES
Hot Current 0 to 70A 20A 1A
YES NO YES
Initial Current 5 to 200A 30A 1A
NO YES YES
Crater Current 5 to 200A 30A 1A
NO YES YES
Pulse Duty 15 to 80 % 50% 1%
NO YES YES
Pulse Frequency 0.5 to 500.0 Hz 100.0Hz *2 NO YES YES
Pre-Flow Time 0.0 to 1.0 sec 0sec 0.1sec
NO YES YES
Post-Flow time 0.0 to 60 sec 10sec 0.1sec NO YES
YES
Spot Time 0.5 to 5.0 sec 2sec 0.1sec NO NO
YES
Up-Slope Time 0 to 15 sec 1sec 1sec
NO YES YES
Down-Slope Time 0 to 25 sec 3sec 1sec NO YES
YES