SanRex SANARG 200AP, Operator'S Manual

Page: 36 / 90

36
3.6 SPECIFICATIONS
3.6.1 INPUT/OUTPUT
PARAMETERS SANARG 200AP
Model IA-2000TP-U2E
Description AC/DC HF TIG, LIFT TIG, STICK
Rated output 200 A at 18 V, 20% Duty Cycle (STICK)
Welding Mode Input Power 40% Duty Cycle 60% Duty Cycle 100% Duty Cycle
Output
Current/Voltage
TIG
208-230/460 1/3Ø 160A@17V 130A@16V 100A@14V
STICK
208-230/460 1/3Ø 160A@27V 130A@26V 150A@24V
Open Circuit Voltage
Approximately 65 V at 230 VAC input
Approximately 18 V with low OCV circuitry enabled
Output Current
Range
TIG 5-200 A (DC Mode) 10-200 A (AC Mode, 60 Hz, 50% cleaning)
STICK 5-160 A (DC Mode) 10-160 A (AC Mode, 60 Hz, 50% cleaning)
Input/Output at
Rated Load
Three-phase Single-phase
Voltage Current Voltage Current
Rated Input
Voltage/Current
208 20 208 44
230 19 230 49
460 10 N/A N/A
Output Amperes 160 160
Output Volts 27 27 Input at No Load
KVA 7.2 9 0.5
KW 5.4 5.4 0.13
Input
Input Voltage 208-230/460 VAC 3-Phase, 208-230 VAC 1-Phase
Line Frequency 50 / 60 Hz
Line Volts
Compensation
+ / - 10%
Input Cable AWG 12/4 SOOW, approximately 10 feet long
Dimensions W: 7.08 in. (180 mm), H: 14.76 in. (375 mm), L: 16.53 in. (420mm)
Weight 37 lb. (17 kg)
SanRex continuously strives to produce the best product possible and therefore reserves the right to change, improve or revise the
specifications or design of this or any product without prior notice. Such updates or changes do not entitle the buyer of equipment
previously sold or shipped to the corresponding changes, updates, improvements or replacement of such items.
The values specified in the table above are optimal values, your values may differ. Individual equipment may differ from the above
specifications due to in part, but not exclusively, to any one or more of the following; variations or changes in manufactured components,
installation location and conditions and local power grid supply conditions.