SanRex SANARG 160P, Operator'S Manual

Page: 37 / 82

37
3.6.2 GENERAL
Model ID-1600TP-U1E
General
Approval/Standard IEC60974-1,IP23S
Language English
Front Panel
Front Panel Pot Welding Current / Parameters Adjustment
Push to voltage display
Function Select Button
Process STICK / HF TIG / LIFT TIG
Mode
See TABLE 1
OUTPUT STD / SLOPE / REPEAT / SPOT
Pulse ON
Parameter Select
Button
Forward
/ Back
See TABLE 2 Current Weld / Hot / Initial / Crater
Pulse Peak / Pulse Base
Pulse Duty / Frequency
Time
Sequence Pre Flow/ Post Flow / Spot
Up Slope / Down Slope
Save / Load Button Save / Load Ch1 – Ch5
Digital Panel Meter
Indicator
Amperage / Parameter / Error Code ( See TABLE 3 )
* Holds weld value for 8sec after weld current has stopped
Value stops displaying if control knob is rotated
LED Indicator Selected Function and Parameter
RED
HOT START, INITIAL CUR, PEAK(WELD) CUR,
BASE,
CRATER CUR, A
PULSE WIDTH, %, PULSE FREQ, Hz
PULSE ON, STD, SLOPE, REPEAT, SPOT,
STICK, HF TIG, LIFT TIG
PRE-FLOW, UP SLOPE, SPOT TIME, DOWN SLOPE,
POST FLOW, sec
GREEN VRD ON
* Both VRD light off in HF TIG & LIFT TIG modes
Shielding Gas Output 5/8 18inch UNF (F)
Cooling Water Output None
Output DIN style
Remote Control 8 pin connector for Torch Control
Rear Panel
ON/OFF Switch Switch
Shielding Gas Input 5/8 18inch UNF (F)
Cooling Water Input None
Size
Width
Height
Depth 130 mm
260 mm
320 mm
Weight (Shipping) 8kg
Material of Outline Case Plastic
Attachment Terminal plug 2 pcs
Operation Manual 1 pcs