Sanotechnik SM101, Mounting Instruction

Page: 21 / 63

5. Press the FM key open FM radio
，
the working indicator will flash at the same time the frequency will be
displayed in the FM radio frequency area that you have memory in the memory number 00 ,and if the memory number 00
have not frequency, 87.0MHz will be display.
Press the FM key again to turn off FM radio.
e. Searching for the broadcast by one step
Press key one times , the frequency will increase 0.1 MHz (MHz is flashing at the same time
）
. press key
one times
，
the frequency will decrease 0.1 MHz (MHz is flashing at the same time
）
.
f. Searching for the broadcast automatically
Press key for a long times
，
it will searching for the broadcast automatically to the higher frequency (MHz is
flashing at the same time
），
and stop when a broadcast found
Press key for a long times
，
it will searching for the broadcast automatically to the lower frequency (MHz flashing
at the same time
），
and stop when a broadcast found.
g. Change the volume
Press key to increase volume and press key to decrease volume.
h. Memory the frequency of the broadcast
（
No:00—19
）
When the broadcast was found press key, to memory the frequency of the broadcast. And if you want to
memory moue , press key to increase the number of the memory
（
No:00—19
）
, then press key or key
to looking for the broadcast and press key to memory the frequency of the broadcast.
e. Get the frequency of the broadcast in the memory
Open the radio by press key, then press key to increase the number of the memory
（
No:00—19
）
.and
the frequency of the broadcast will be displayed in the FM radio frequency area.
Note: the number of the memory
（
No:00—19
）
will be replace by the bass room temperature after 10 sec.
6
．
Setup maximum temperature of bass room
Press key to setup maximum temperature of bath room between 25-60 (
℃
is flashing ).when the
temperature of bath room is equal or higher then you setup, the steam generator will stop automatically.
Note
：
after you setup the maximum temperature 10 min. it will be replaced by bath room temperature.
7
．
Setup working time of the steam
Press to Setup working time of the steam between 5-60 min( is flashing ), and it will be decrease when the
steam generator working until it decrease to 00 min. the steam generator will stop automatically.
Note
：
after you setup the maximum temperature 10 min. it will be replaced by bath room temperature.
Please press key to shut off the power of the controller
Page 5