Sanotechnik 10591131, User And Installation Manual

Page: 18 / 72

18
• After 1 minute without any action, the module automatically exits the setting mode;
• After a power cut, the settings are retained, a new setting of the day and time may be necessary;
LOCK/UNLOCK CONTROLS
The controls can be locked to prevent unintentional use. To do this, simultaneously
press the and keys for more than 3 seconds: the symbol appears. Proceed in
the same way to unlock the controls: the symbol appears.
ADVANCED FUNCTIONS
To have access to the advanced functions of the device, the thermostat must be in Ma-
nual or Program mode.
Calibration
A difference between the setpoint temperature and the temperature actually measured
in the room is possible, it is generally due to the installation conditions of the heater
(location, power / volume, insulation of the room, ..). Calibration adapts the thermostat
setting to actual room conditions.
1. Place the heater in Manual mode on 20 ° C and wait several hours;
2. Measure the room temperature using a thermometer and calculate the difference:
deviation = measured temperature - setpoint temperature;
3. Press the and keys at the same time for more than 3 seconds to display ;
4. Press , flashes alternately with the currently set deviation;
5. Set the new value with the and keys (between -3 °C and + 3 °C);
6. Press to exit;
Maximum temperature
The heater makes it possible to record a maximum temperature (between 19 °C and 28
°C) which cannot be exceeded during adjustments. By default, it is set to 28 °C.
1. Press the and keys at the same time for more than 3 seconds to display ;
2. Press to display ;
3. Press , flashes alternately with the currently set maximum temperature;
4. Set the new value with the and keys (between 19 ° C and 28 ° C)
5. Press to exit;
Heating indicator in standby mode
After a few seconds without any action, the display of the control box turns off automa -
tically, except the heating LED which lights up when the heating element is supplied. It
is possible to set the thermostat so that this indicator goes off when the display of the
thermostat goes off.
1. Press the and keys at the same time for more than 3 seconds to display ;
2. Press twice to display ;
3. Press , flashes alternately with ;
4. Press to display ;
5. Press to exit;
12. Go back to point 4 for each of the programs to modify;