Page 2
Step 1. Check the insulin
A
. Check the label on your SoloSTAR
to make sure you have the correct insulin. The Lantus
SoloSTAR is grey with a lilac injection button.
B.
Take off the pen cap.
C.
Check the appearance of your insulin. Lantus is a clear insulin. Do not use this
SoloSTAR
if the insulin is cloudy, colored or has particles.
Step 2. Attach the needle
Always use a new sterile needle for each injection. This helps prevent contamination, and
potential needle blocks.
Before use of needle, carefully read the “Instructions for Use” accompanying the needles.
Please note: The needles shown are for illustrative purposes only.
A
. Wipe the rubber seal with alcohol.
B.
Remove the protective seal from a new needle.
C.
Line up the needle with the pen, and keep it straight as you attach it (screw or push on,
depending on the needle type).
•
If the needle is not kept straight while you attach it, it can damage the rubber seal and
cause leakage, or break the needle.
Step 3. Perform a safety test
Always perform the safety test before each injection. This ensures that you get an accurate
dose by:
•
ensuring that pen and needle work properly
•
removing air bubbles
A
. Select a dose of 2 units by turning the dosage selector clockwise.
