Sanli Blower / Blower Vac User Guide
9
Basic maintenance made easy.
WARNING! If your Blower or Blower Vac is not serviced correctly,
you could void warranty and reduce its ability to operate effectively.
1. Spark plug.
Wait until the engine has cooled before disconnecting the spark plug cover and then
removing the spark plug with the box spanner supplied. If it is dirty, you can clean the
plug with a wire brush.
The applicable spark plug for this machine is the NGK BPMR7A. For optimum results
we advise you to replace the spark plug after 20 hours of use.
When refitting the spark plug take care not to over-tighten. If adjusting yourself, note that
the spark plug gap must be set to 0.6 to 7.0mm.
2. Air filter.
Ensure that the engine is cool, remove the air filter cover and then take out the air filter
element, see
(Figure 11)
. Put the cover back on the housing immediately to prevent any
objects falling into the air intake.
Carefully brush off any excess dirt particles, or clean filter element using lukewarm soapy
water. When cleaning with water, rinse thoroughly and allow to dry before replacing air
filter element.
3. Storing petrol and oil.
WARNING! Petrol is highly flammable so extreme caution must
be taken. Always store petrol in approved containers and ensure
petrol is less than three months old.
Carbon
0.6mm
Air filter
element
Figure 11.
