SANLI LazerCut LCS405, Instruction Manual

Page: 6 / 19

PAGE 6
INSTRUCTION MANUAL
BEFORE YOU BEGIN
WARNING!
The following procedures must be carried out before you start the engine of your lawnmower.
FILL OIL SUMP WITH 600ml of
SAE 30 Oil FILL FUEL TANK WITH
PREMIUM PETROL (NO
E10 PETROL)
!
MAX MIN
Filling oil sump with oil
The mower is supplied with oil in
the engine. You have to add 600ml
oil before starting the engine for
the rst time.
1. Firstly, remove the warning
label from under the dipstick,
then remove the dipstick and
slowly pour 600ml of SAE30
or 10W/30 lawnmower grade
engine oil into the engine via
the oil ller (Fig. 1). Replace the
dipstick and tighten.
2. Before you use the mower each
time, check the oil level (Fig.
2) and if necessary top up with
SAE30 engine oil. To check the
oil level, unscrew the yellow
dipstick, wipe with a rag and
replace into the oil ller (do not
screw back in place),
remove the dipstick again and
check the level.
3. The oil level must be between
the min and max marks on the
dipstick (Fig. 3). Replace the
dipstick and screw into place.
Fill Fuel tank with min 95 octane
premium unleaded petrol (Do not
use Ethanol petrol ie. E10).
Petrol is highly ammable so
extreme caution must be taken
when handling it. Always store
petrol in approved containers and
you must ensure that you use fresh
petrol that is less than 4-6 weeks
old. Do not mix oil with petrol.
4. To put petrol in the fuel tank,
rstly remove the warning label
from under the petrol cap.
It’s best to ll the tank using
a clean funnel, but never ll it
completely (Fig. 4) . Instead,
leave at least 13mm from
the bottom of the ller neck to
allow for expansion. Ensure that
you securely tighten the petrol
cap after lling. (F
unnel & Fuel
not supplied) .
Fig 1 Fig 2 Fig 4
Fig 3