13
·
Pull the starter rope at least 10 times
Operation instructions
During break-in
A new machine should not be running at high speed. This avoids
unnecessary high loads during the break-in period. As all moving parts
have to e fitted during the break-in period. The frictional resistances in
the engine are greater during this period. The engine develops its
maximum power after about 5 to 15 tank fillings.
During operation
After a long period of full-throttle operation, allow engine to run for a
while at idle speed so that the heat in the engine can be dissipated by
flow of cooling air. This protects engine-mounted components
(ignition, carburetor etc.) from thermal overload.
After finishing work
Storing for short period:
Wait for engine to cool down. To avoid condensation, fill the fuel tank
and keep the unit in a dry place until you need it again. Storing for a
long period: see chapter “Storing the machine”
Cleaning the air filter
Dirty air filters reduce engine power, increase fuel consumption and
make starting more difficult.
If there is noticeable loss of engine power
·
Close the choke
·
Pull A and remove the air filter cover
·
Remove the filter from the cover and inspect it. If it is dirty or
damaged, clean the filter or fit a new one.
·
Install the filter
·
Fit the cover and tighten the screws
A
Summary of Contents for BSB 33
