Sanity AP 2516, User Manual, Page: 8 / 66

EN RU EE LT LV MD RO GE
OPERATING YOUR COMPRESSOR NEBULIZER
Caution!
The product must be used in accordance with the recommendations
described in the operator
’s manual.
The user may not implement any changes to the product.
Dear Customer
– like any electrical device, our product may disturb the operation of other
electrical devices, such as cell phones, wireless telephones, routers
– safe distance
from other electrical equipment with regard to device operation is approximately 1 meter.
Caution!
Prior to initial operation, the nebulizer should be thoroughly cleaned.
1. Place your compressor nebulizer on a flat and stable surface. Be sure
that you can easily reach the controls when you are seated.
Important: Prior to initial operation, the nebulizer should be thoroughly
cleaned referring to the
“Cleaning Procedures” in the manual.
2. Gently twist the top part of the nebulizer bottle counter-clockwise
to disassemble the nebulizer bottle.
3. Fill the bottom section of the nebulizer bottle with the medication
prescribed by your physician. Be sure that the cone
is put inside the bottom section and an upper part
is yellow sleeve with the tabs pointing upwards.
4. Gently twist the top part clockwise to and fill medication re-
assemble the nebulizer. Be sure the two sections fit well.
5. Attach one end of air tube to the base of the nebulizer bottle.
6. Attach the other end of air tube to the air tube
connector located on the front of the compressor.
7. Attach mouth piece or mask per your choice to the
top section of nebulizer.
8. Plug the power cord into an appropriate electrical outlet. Make
sure at this stage, the power switch is at
“OFF” status.
9. Press power switch to begin your prescribed treatment.
10. After the end of inhalation, turn the machine off
and turn it from the mains.
Place cone
inside and fill
medication
Important: The compressor motor has a thermal protector
which will shut off the unit before the unit is overheated. When the
thermal protector shuts the unit off, please:
a. Set the switch in the OFF position.
b. Unplug the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before another treatment.
Make sure the air openings are not obstructed.
11. When treatment is finished, shut off the unit and unplug it from the electrical outlet.
7