Sanitas SBC 24, Instructions For Use Manual, Page: 49 / 52

49
Electromagnetic Compatibility Information
Table 1
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer’s declaration – electromagnetic emissions
The SBC 24 is intended for use in the electromagnetic environment specifi ed below. The customer or the user of the SBC 24 should assure that it is used in
such an environment.
Emissions test Compliance Electromagnetic environment – guidance
RF emissions CISPR 11 Group 1 The SBC 24 uses RF energy only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in nearby electronic equipment.
RF emissions CISPR 11 Class B The SBC 24 is suitable for use in all establishments other than domestic and those
directly connected to the public low-voltage power supply network that supplies buildings
used for domestic purposes.
Harmonic emissions IEC 61000-3-2 Not applicable
Voltage fl uctuations / fl icker emissions
IEC 61000-3-3 Not applicable
Table 2
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer’s declaration – electromagnetic immunity
The SBC 24 is intended for use in the electromagnetic environment specifi ed below. The customer or the user of the SBC 24 should assure that it is used in
such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic environment – guidance
Electrostatic discharge (ESD)
IEC 61000-4-2 ± 6 kV contact
± 8 kV air ± 6 kV contact
± 8 kV air Floors should be wood, concrete or ceramic tile. If fl oors are covered with
synthetic material, the relative humidity should be at least 30 %.
Power frequency (50 / 60 Hz)
magnetic fi eld IEC 61000-4-8
3 A/m 3 A/m
Power frequency magnetic fi elds should be at levels characteristic of a typi-
cal location in a typical commercial or hospital environment.
NOTE: U
T
is the a.c. mains voltage prior to application of the test level.