4. Set the control switch to the
“CLEANOUT”
position
and agitate for approximately 1
- 2 minutes and then
drain the water by opening the spigot. After the unit is
empty, set the control switch to the
“OFF”
position.
5. Remove the front plate by turning the black plastic
knobs in a counterclockwise direction (Fig. 5).
Disassemble the front plate in the following manner:
DO NOT USE ANY TOOLS OR SHARP OBJECTS TO
REMOVE ANY O-RINGS FROM THIS MACHINE.
SHARP OBJECTS WILL DAMAGE THE O-RINGS.
a. Remove the faspin and spigot handle.
b. Remove the front plate o-ring.
c. With the spigot handle removed, push the spigot
plunger out the top of the front plate.
d. Remove the o-rings from the spigot plunger by
grasping the part with one hand and with a dry
cloth in the other hand, squeeze the o-ring upward.
When a loop is formed, grasp the o-ring with the
other hand and roll it out of its groove and off the
part (Fig. 6).
6. Remove the carburetor tube (Fig. 7) from the mix
pan. Disassemble and clean in the following manner:
a. Remove the o-ring from the bottom of the tube.
b. Clean the inside of the tube with the brush.
7. Remove the dasher assembly (Fig. 8) being careful
not to damage the scraper blades, then disassemble
in the following manner:
a. Remove and take apart the rear seal assembly.
b. Remove the stator rod from the dasher.
C.
Remove the blades from the dasher (Fig. 9a)
by first rotating blade upward (Fig. 9b) and then
unsnapping one end from the support rod.
BLADES MUST BE REMOVED FOR CLEANING.
IMPORTANT
DISASSEMBLY & CLEANING
Fig. 5
Face Plate Assembly
Spigot Plunger
Faspin
Spigot
Handle
Front Plate
Front Plate O-ring
DO NOT LUBRICATE
Spigot Plunger
O-rings
Front Plate
Knobs
Fig. 6
O-Ring Removal
Fig. 7
Carburetor Tube Assembly
Scraper
Blade
Rear Seal
Stator Rod
Rear Bearing
Dasher
Fig. 8
Dasher Assembly
PAGE 4
O-ring
Mix
Inlet
Hole
Shake
SoftServe
