Installation Procedure
Notes: To ensure the normal use of products, it is required you set out wires as per
the regulations at the installation places. The Products are only applicable to being
installed on the indoor solid wall.
The installation must be carried out by a professional
electrician and wrong installation may lead to product damage and personal injury.
1. Make certain the wall is solid, and use the flexible rule to measure the distance
between two hardy holes on the mirror frame ("a” in Fig. 1).
2. Use the flexible rule to measure the distance a on the wall and mark them out
with a pencil.
3. Choose a drill with an appropriate drill bit to make two holes at the marked
places, and use a special ceramic drill if the wall surface is made of ceramic tiles.
4. Use the hammer to strike an expansion rubber plug into the holes on the wall,
and then screw the hook into the hole (Fig. 2).
5. Switch off the power, and then use a terminal block to connect the three-core
exposed wires with those reserved on the wall (see details in Fig. 4).
6. Hang the product on a wall hook (Fig. 3).
7. Finally switch on the power, and then touch the switch sign with a finger on the
sensor to test the products.
Installation Procedure
Flexible rule
Spirit level
Drill
Hammer
Pencil
Fig. 1
Fig. 2
Fig. 3
*2
*2
Wire outlet
Back cover
Hanging hole
a
a
