Sanipex BAGNODESIGN KOY BDB-KOY-879-MB, Installation Manual

Page: 5 / 8

• Attach waste fittings and fix your
bath using white/clear bath
sealant which must be applied to
bottom face of bath. Clean off any
excess and be careful not to over
silicone.
• Unsure the supplied flexible waste
connector kit is securely
connected to the bath and waste
outflow system before positioning
the bath.
NOTE
• Assembly order for optional plinth installation.
Do not drag the bath over any surface,
but rather lift and place.
Do not drop your bath!
Optional Plinth
• Always protect the surface when handling or installing/assembling –
cardboard provides adequate protection on the floor or an old blanket.
• Try and avoid getting cement, grit, sand or masonry products onto the
surface. Prevention is better than cure.
•
Always protect and cover the bath during the installation process and
construction phase of your bathroom – other trades will damage the bath if
no precautions are taken.
•
Provide the bath to construction sites at the correct time as storage on site
can lead to damages.
•
Never use buff tape directly onto the surface. If inspection and repackaging
is required remember to avoid taping directly onto the surface.