Assemble the parts as per the diagram.
Ensure that the mains water supply is turned off before installation .
Install taps and spout connection (1 & 2) (Connection pipes not supplied) at a
depth so that the finished surface is between the Min/Max distance markings
shown in the diagram. Connect the Hot and Cold water supplies to the taps, and
cap off the connection, then check for leaks at the connections'. Place on the
protection covers (3 & 4).
Once the surrounding finishes have been applied (Tiles/Marble etc.) remove the
protection covers (3 & 4) and discard. Screw on the shrouds (5) until secure
against the wall surface. Fit the base plates (6 & 10) against wall surface. Push the
spout (11) into place
screwed in the concealed part using hamp or teflon
(9). Place
handle (8) onto the spindle and secure
it
(7). Repeat for other valve. Open the
water supplies and re-test for leaks.
' Before making any inlet pipe connections, all supply pipes MUST be thoroughly
flushed to remove debris. Failure to do this could result in damage to the
cartridge and components or low flow from the mixer'
3
Hole Wall Mounted
Basin Mixer
Ø52
70
Ø52
G 1/2
116
Ø24
52
190 MAX
54-74
