Sanipex BAGNODESIGN BDA-MLI-060 Series, Installation Manual

Page: 4 / 8

The following manual has been elaborated in order to supply all the useful
information for a correct installation together with the precautions to adopt both
from installer and users. Manufacturer declines every responsibility in case of
different uses from these instructions.
The heated towel rails is connected to the mains with a z type connection, and
consequently it cannot be substituted in any case of damage. Such an action would
make the item dangerous and free the producer from every responsibility.
ATTENTION : This item can be only used as holder for towels and similar garments.
This item, in normal use, cannot be loaded with more than 5 Kg . weight.
Please, only use provided screws and dowels or replace them with other ones
equivalent or greater in mechanical characteristics.
DEGREE OF PROTECTION: IPX4 splash-proof device.
PACKING CONTENTS : (see image 1)
(4) Confection screw with dowel
(1) Confection screw with dowel for flange per BOX
(1) Flange for switch BOX
(1) Screw for flange fixing BOX M6 X 6
(1) Instruction & Operation Manual
Raw material : Brass, Operation: Electrical
INSTALLATION: (see design 1)
Take out the heated towel rail and its components from the package.
For wall mounting, bring the item to the wall mark the position of the supports and
drill the holes in the wall where to place the wall connection.
Fix the wall connection by passing the wire through the hole in the wall of the
attack.
Then connect the wires to the terminal provided.
Below place the towel bar on the wall connection and secure it with the Allen
screws contained in the package.
Only after finishing this action, you can turn the power on and verify the heated
towel rails works correctly.
Our Company refuses any responsibility in the case the assembly doesn’t respect
the above mentioned instruction.