If you have a 2 U server, the 1 U faceplate will need to be removed to install the 2 U faceplate.
If this is your case, please view the following Demo which indicates which screws to remove and how to separate the card
Hardware Configuration
-> NT Power Adapter "SPEC-BNPWR1" -
is required
When using FXS modules, an internal 12V power to A200 main board
.
Use 4-pin Molex power connector from server power supply
B700 BRI Termination resistors to switch between NT and TE modes
The B700 comes with termination resistors that have to be disabled (set to OFF) when running in TE mode and enabled (set to ON) when
running in NT mode.
The resistors corresponding ports 1 and 2 are closest to the PCI base.
The ON position is closer to the NT/TE modules.
The OFF position is closer to the RJ-45 connectors.
