5
GB
Auto tuning - FM
. Press the Power button to turn on the radio.
. Press the Band button to get required waveband, then extend
the FM wire antenna located in the battery compartment to get
best reception.
. Press the Select button repeatedly until ‘Auto tune <>’ shown on
the display.
4. Press the Tuning Up button. Your radio will scan from the currently
frequency direction upwards and will stop scanning when it finds
a station of sufficient strength.
5. The display will show the frequency of the signal which has been
found. If RDS information is available, after a few seconds the
display will show the radio station name. The display will also
show “St” and “RDS” on the upper line if the station is received
with stereo and RDS information.
6. Press the Tuning Down button to scan the FM band in a downwards
direction (high frequency to low frequency).
7. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
8. Adjust the Volume control to the required setting.
