13
Scan sensitivity setting – FM
Your radio will normally scan for FM broadcasts which are strong
enough to give good reception. However, you may wish the Auto
scan function to also be able to find weaker signals, possible
from more distant radio transmitters. Your radio includes a local /
distant option for the Auto-scan function.
1. Press and hold the Power button to switch on your radio.
2. If needed, press the Band button to select the FM band.
3.
Press and hold the Info button to enter the FM menu setting.
4. Press and release the Tuning Up or Down buttons until the
display shows “FM Scan Zone” then press the Select button to
enter the scan zone setting.
5. Press the Tuning Up or Down buttons to switch between Local
and Distant options on the lower line of the display. The Distant
option will allow the radio to find weaker signals when scanning.
6. Press the Select button to confirm your selection. The radio
will then revert to the normal information display. The Local or
Distant setting is stored in the radio and remains in force until
changed or until a System Reset.
Note:
The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weak (distant) signals.
Clock and Alarms
Automatically updating the clock
You can specify that the unit sets its clock from DAB or FM radio
broadcasts. After a power failure the radio will then set its clock
the next time that you turn on the radio in DAB or FM mode.
Alternatively you can specify that the time is not automatically
updated. In this case the clock must always be set manually after
a power interruption.
1 . With your radio switched on, press and hold the Menu button to
access the menu for the current mode.
2. Press the Tuning up/down button until “Time” is highlighted on
the display. Press the Select button to enter the setting.
3. Press the Tuning up/down button until “Auto” is highlighted on
the display. Press the Select button to enter the setting.
4. Press the Tuning up/down button to choose an update option
from
“DAB”, “FM”, “Any” or “No”
as required. Press the Select
button to confirm your choice. The radio will then exit to the
previous menu setting.
Summary of Contents for DPR-64
Page 1: ...Version 1 GB DPR 64...
