15
Setting the alarm
When the radio is on/standby, repeatedly press and release the
Advanced INFO button until the lower line of he display shows alarm
status. Press Tuning Control button to select Alarm Status on/off.
During Alarm Status in ON status, display will auto switch to alarm
time setting. The minute will start to flash, rotary the tuning control
knob to select required minute then press and release the tuning
button again, the hour will start to flash, rotary the tuning control knob
to select required hour, then press and release the tuning button
again to finalize alarm time setting. Display will show Alarm Status
ON after completing the alarm settings.
Select alarm by radio or beep
During Alarm Status ON, rotary the tuning control button to select
Alarm type (Radio or Beep) pressing and releasing the tuning control
button to change alarm type.
Stop the alarm
When alarm is active, press the Standby button to stop the alarm
(radio and buzzer).
Snooze
To interrupt the alarm signal (radio or beep), press Tuning Control
button. The alarm stops and begins again with interval of 5 minutes.
The alarm will continue for an hour (radio, 30 minutes for Beep) if not
being interrupted. Display will show during Snooze status.
Canceling the alarm
Same procedures of setting the alarm, press and release Tuning
Control button to switch the alarm off.
System reset
If your radio fails to operate correctly, or some digits on the display
are missing or incomplete, carry out the following procedures.
1. Switch on your radio.
2. Continuously press Advanced INFO button until display lower
part shows “ Customer.....“, press and release Advanced INFO
button until display lower part shows System Reset.
Press and release Tuning Control knob, the radio will be reset
and quick scan 10A-12D for services and stop at the first
service found. The RESET will clear all the previous memory
presets and settings.
DDR-3_381K801A_GB.p65
2004/2/27, 下午 02:09
16
