6
2. Setting roll paper
Roll paper can be set inside the main body. Pull the main body out from the front surface and
set roll paper.
(1) While pushing the lock levers on both sides of the panel, remove the panel.
(2) Use the pull-out knob to draw the body inside the printer, and set roll paper onto the roll
paper fixing shaft. (Horizontally cut the tip of roll paper as shown in Figure 1.)
Note: The pasted section of roll paper does not accept printing, so cut roll paper for the
corresponding section without the pasted section.
When setting roll paper with the power ON, be sure to use the pull-out
knob to draw the board. Because a small amount of current is flowing in
it, do not touch the board directly.
Caution
Roll paper
fixing shaft
Remove
Push
Pull-out knob
Note: Properly set roll paper while
checking its direction.
Push
Fig. 1