KWS 3000-CML - User Guide, Rev.1.0
// 33
7.2.2.
Installing and Removing M.2 Modules
Figure 14: M.2 Modules Location
1
M.2 SSD module location
2
M.2 Wi-Fi module location
Due to the M.2 sockets location underneath the PCIe expansion cards and underneath the
heatsink, the M.2 modules are factory installed.
To remove a M.2 module(s), perform the following:
1.
Shut down the product properly using power button, PSU switch and disconnect the power cable from the
input power socket or mains power outlet
2.
Open the service cover, see Chapter 7.2: Opening and Closing the Service Cover.
3.
Release the screw fastening the M.2 module(s) to the motherboard. Retain the screw for later user.
4.
Removed the M.2 module by carefully holding the sides of the M.2 module and pulling the M.2 module out of
the socket. Retain the M.2 module with screw for reuse.
5.
Close the service cover, see Chapter 7.2: Opening and Closing the Service Cover.
To insert a M.2 module(s), perform the following:
1.
Shut down the product properly using power button, PSU switch and disconnect the power cable from the
input power socket or mains power outlet
2.
Open the service cover, see Chapter 7.2: Opening and Closing the Service Cover.
3.
Locate the corresponding M.2 socket and insert the new M.2 module(s) into the socket at an angle (approx.
30°). If required move the M.2 module slightly from side to side to ease the module carefully into the socket.
4.
Fasten the M.2 module by pushing down on the M.2 module’s free end until the M.2 module’s screw hole aligns
with the screw hole on the motherboard and fasten the screw to secure the M.2 module.
5.
Close the service cover, see Chapter 7.2: Opening and Closing the Service Cover.
2
1
