KWS 3000-CML - User Guide, Rev.1.0
// 30
7/
Assembly
Before Opening the Service Cover for Assembly
Before opening the service cover to assemble and handle internal components, observe the safety instructions in
Chapter 1/ General Safety Instructions and consult the documentation provided by the components manufacturer.
Energy hazards present
Before removing the service cover, shut down the product properly using power button, PSU
switch and disconnect the power cable from the input power socket or mains power outlet.
ESD Sensitive Device
Electronic components are sensitive to static electricity. Therefore, care must be taken
during all handling operations and inspections.
A sudden discharge of electrostatic
electricity can destroy static-sensitive devices.
Opening and Closing the Service Cover
To open the service cover to gain access to internal components, perform the following:
1.
Shut down the product properly using power button, PSU switch and disconnect the power cable from the
input power socket or mains power outlet.
2.
Remove the three service cover screws (screwdriver: torque 10) on the rear panel, and retain for later use.
Figure 12: Removing the Service Cover
3.
Slide the service cover away from the front panel by approximately 20 mm to release the metal catches on the
underside of the service cover from the front panel’s internal plate and the sides of the chassis.
4.
Lift the service cover upwards to remove.
