KBox B-201 - User Guide, Rev. 1.3
// 37
8.3.
Mounting Brackets (Option)
To wall mount (vertically or horizontally) as shown in Figure 25, or fixed desktop (underneath or on top) of a desktop
use the mounting brackets as shown in Figure 24.
Each mounting bracket contains two sets of mounting holes to fasten to the KBox B-201.
Figure 21: Mounting Bracket
1
Mounting holes (10 mm keep out area)
2
Mounting holes (no keep out area)
3
Key mounting holes for mount surface
Each mounting bracket supports two sets of holes. Which set of holes is used depends on whether a keep out area is
required for ventilation
If the top cover ventilation holes face the mounting surface, a 10 mm keep out area is required between the top
cover and the mounting surface to ensure adequate ventilation. The mounting holes shown in Figure 21, pos. 1
must be used.
If the bottom side faces the mounting surface, no keep out area is required between the bottom side and the
mounting surface as the bottom side does not contain ventilation holes and the mounting holes shown in Figure
21, pos. 2 can be used.
Obstructing the ventilation holes may cause overheating
Do not to place items directly in front of the top cover ventilation holes and observed that all
ventilation openings are not covered or obstructed by objects.
Leave sufficient clearance (keep out area) to prevent the device from possibly overheating!
To ensure proper operation, use the specified recommended keep out areas of:
Top cover: 10 mm (0.394")
left and right side: 10 mm (0.394")
Front and rear panel: 10 mm (0.394")
Bottom side ( no keep out area)
To mount using mounting brackets:
1.
Consider which set of mounting holes is required for the mounting option.
If mounting with the top cover ventilation holes facing the mounting surface, use the mounting holes shown
in Figure 21, pos. 1.
If mounting with the bottom side facing the mounting surface, use the mounting holes as shown in Figure 21,
pos. 2.
2.
With either the right or left sides facing upwards, align the mounting bracket’s mounting holes with the
correct mounting-hole pair on the KBox B-201’s side.
1
2
3
