KBox B-201-CFL - User Guide, Rev 1.3
// 30
6.2.
Opening and Closing SSD Drive Bay Cover
Before opening the SSD drive bay, observe to the safety instructions at the start of this chapter.
Before installing a 2.5” SSD, observe the manufacturer’s instructions.
To open the SSD drive bay, perform the following:
1.
Close all applications. Shut down the product properly and disconnect the power cable from the power
source. Disconnect all peripherals.
2.
Place the KBox B-201-CFL on a flat, clean and ESD-safe surface with the bottom side facing upwards.
3.
Remove the screw holding the SSD drive bay cover using a torx screwdriver (08 x 60) (Figure 9, pos. 3).
4.
Lift the SSD drive bay cover a few centimeters to release the SSD from the internal SSD holding-plate on the
rear side of the SSD drive bay cover (Figure 12).
Figure 12: SSD Drive Bay Cover Rear Side
5.
Slide the SSD drive bay cover forward slightly, to release the two aligning tabs (Figure 13).
Figure 13: SSD Drive Bay Cover Top Side
6.
Lift to remove the drive bay cover.
7.
Close the SSD drive bay cover, by proceeding in the reverse order (steps 6 to 3).
To avoid damaging the SSD drive do not force when closing the SSD drive bay cover
When closing the SSD drive bay cover do not use force. If the cover does not close easily, the
metal SSD holding-plate on the rear side may not be aligned correctly and may be pressing
on the SSD.
SSD holding-plate
Aligning tabs